Select the first symbol variant at the upper left of the preview and click.A preview of all available variants of the selected symbol is shown at the right-hand side. This is a single-line motor overload switch with 6 connection points. Select the symbol Q元 with the symbol number 124.Click in the symbol selection list on the Name column heading so that the symbol names are displayed in ascending order.Enter the characters 'ql3' into the Direct entry field.Only single-line symbols are now available for selection. Select the 'IEC symbols, single-line' entry in the Filter drop-down list in the Symbol selection dialog.ĮPLAN creates a page of page type Schematic single-line and opens it in the graphical editor. In the New page dialog, select the entry 'Schematic single-line (I)' from the Page type drop-down list and click.You have access to a single-line symbol library.Ĭreate a page for single-line representation.A connection definition point is used to designate the resulting connection. Two symbols (a motor overload switch and a three-phase motor) are then placed on this page and connected to each other using autoconnecting. First, a single-line schematic page is added to the project. The following section describes the creation of a simple single-line schematic page.
